Civil Engineering

All Q&A

Design of Reinforced Concrete Structures

What is Bent up bar in Beam?

20 September, 2024

A bent-up bar in a beam is a type of reinforcement bar (rebar) that is angled or bent upwards at a specific point along the length of the beam.

What is the minimum specing of strriup according IS456:2000?

20 September, 2024

According to IS 456:2000, the Indian Standard for plain and reinforced concrete, the minimum spacing for stirrups in beams is specified as follows:

What is strriup ?What is the function of strriup?

20 September, 2024

A stirrup is a piece of steel reinforcement used in concrete beams and columns. It's usually shaped like a closed loop and wraps around the main vertical rebar.

What is flange beam?

20 September, 2024

A flange beam is a type of beam that has wide extensions, called flanges, at the top and bottom. These flanges help the beam handle bending and shear forces much better.

What is the definition of a overhanging beam?

20 September, 2024

An overhanging beam is a beam that extends beyond its support at one or both ends. Unlike a regular beam that's fully supported, an overhanging beam has parts that stick out past where it’s held up.

What is the definition of a cantilever beam?

20 September, 2024

A cantilever beam is a type of beam that is secured at one end while the other end extends out into space. This design allows it to carry loads applied to the free end without needing additional support below

What is the definition of a simply supported beam?

20 September, 2024

A simply supported beam is a beam that’s supported at both ends, letting it span freely between those points. It can move and rotate at the ends without any restrictions, which means it can flex under load.

Subjects

Software Engineering Data Structures & Algorithm surveying Computer Graphics and Multimedia Irrigation Engineering Electrical Engineering Management

Browse Streams